Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Fence Installation: The Orlando Owner’s Guide
Wellborn fence installation in Orlando typically runs $3,500 to $9,000 fully installed, depending on fence height, linear footage, gate hardware, and whether we’re pulling and resetting posts or working with existing footings. Most Wellborn fence sections we handle are aluminum or vinyl privacy panels, and we can usually match the exact profile and color from the manufacturer spec stamped on the back of a picket or rail. The call usually starts the same way: a section is leaning after a storm, a gate won’t latch, or a post snapped at the base from years of Florida rain and sandy soil shifting. You don’t need a whole new fence. You need the failed section matched and set right. That’s what we do, and we give you a written price before any work starts.
Key Takeaways:
- Wellborn fence installation in Orlando costs $3,500 – $9,000 installed
- We match existing Wellborn profiles, colors, and gate hardware; you don’t replace the whole fence for one failed section
- Written price before work starts, no change orders at the door
- 365-Day Done Right Promise: if the repair fails, we come back and make it right, in writing
Which Wellborn Models This Applies To
Wellborn doesn’t build fences the way it builds cabinetry. The Wellborn name on fence products shows up through their outdoor living line, mostly aluminum and vinyl privacy fencing sold through building supply yards in Central Florida. The compatibility piece matters because Wellborn fence sections changed post and rail dimensions over the years. Older Wellborn aluminum panels seat into 2″ x 2″ posts with a notched rail pocket; newer vinyl runs use a 2½” post sleeve and a snap-in top rail. If you mix an older rail profile with a newer post, the section sits loose and rattles in wind. We measure the post face width, rail pocket depth, and picket spacing on site before ordering anything. That’s the gotcha most people miss: two Wellborn fences built five years apart don’t always share interchangeable parts.
As an independent service provider, Sawyer Remodel Orlando isn’t affiliated with Wellborn. We’re a general contractor that installs and repairs their fence lines using OEM-matching profiles when available and quality aftermarket equivalents when the original profile is discontinued. For Wellborn specifically, aftermarket aluminum panels from the same Florida distributors often save 20 to 30 percent over OEM and the gauge, powder coat, and rail depth are identical. We show you both options before you spend a dollar.
Styles & brands we work with
Signs Your Wellborn Fence Installation Is Failing
- Post lean after a storm. In Orlando’s sandy soil, a post that leaned during a heavy rain usually means the concrete footing was poured too shallow or water has eroded the base. The post itself is usually fine; the footing failed.
- Gate won’t latch or drags. This is almost always a hinge-side post pulling out of plumb. In College Park and Winter Park we see this a lot on older lots where the ground settles unevenly.
- Rattling rails in the wind. The rail pocket screws have stripped or the pocket grommets dry-rotted. It starts as noise, then the rail drops and the section sags.
- Pickets pulling free at the bottom channel. Florida humidity swells the vinyl, then heat shrinks it. The bottom channel is the weak point on most Wellborn vinyl panels after six to eight years of Orlando sun exposure.
- Galvanized fasteners rusting out. If you see rust streaks under the rail caps, the original installer used non-stainless screws. They’ll fail completely in a few more seasons.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Orlando, a section-by-section Wellborn fence repair runs lower than a full replacement, but if you’re replacing 100 linear feet or more with new Wellborn-matched panels, gates, and posts, you’re in the $3,500 to $9,000 range. What moves the number: fence height (4 ft versus 6 ft), number of gates, whether the old concrete footings need pulling, and whether we’re matching OEM Wellborn profiles or using distributor-equivalent panels. Full tear-out and disposal adds to the low end; a clean section swap on existing posts keeps you lower.
Every quote includes the parts, the post work, gate adjustment, cleanup, and haul-away if needed. You get a written line-item price before we start, and the invoice you approve is the invoice you pay. The work carries our 365-Day Done Right Promise: if a post shifts, a gate binds, or a section fails within a year, we come back and fix it in writing, not as a courtesy.
DIY or Call Us?
You can check a few things safely: look at the post base for cracked concrete, wiggle the gate hinge mounting area, and note whether rails are fully seated. What you shouldn’t do is pull a leaning post yourself if the section still holds tension from a sprung rail. A loaded vinyl or aluminum panel that lets go while you’re prying at it swings fast and can take off a finger or crack a jaw. We’ve also seen homeowners set a new post in the same washed-out hole without addressing drainage, then call us six months later with the same lean. Colored concrete and a new post don’t fix bad water flow.
If the section is off the posts already and dry-laid on the ground, most Orlando homeowners can handle a simple picket reinsert. But if the post is down, the gate is involved, or you’re not certain of the panel profile, call us at (850) 809-0306. Luca Romano will tell you straight whether it’s worth your weekend or whether we should just come set it right.
FAQs
A Wellborn aluminum fence installed correctly in Orlando lasts 20 to 30 years; vinyl goes 15 to 20 years before UV embrittlement becomes visible, but posts and footings are the real limiter in our sandy, wet Florida soil. Call (850) 809-0306 if your posts are leaning before the panels show wear, that’s a footing problem, not a panel problem.
Yes, most sections can be repaired by re-seating rails, replacing stripped fasteners, and resetting posts in deeper concrete footings with proper drainage. If the panel itself is cracked through or powder coat is peeling across the face, replacement is cheaper long-term. We’ll show you both numbers before you commit.
One section swap takes our crew a morning; a full gate rebuild with new posts takes a day; a full 100-foot replacement runs two to three days in Orlando weather, with cleanup and haul-away included.
We stock the most common Wellborn rail pockets, post caps, gate hinges, and stainless fasteners on the truck; full panel sections and matching posts are ordered from our Orlando distributors and usually arrive within three to five business days. We also stock parts for KraftMaid, Cambria, and Silestone lines for cabinetry and countertop work if your fence repair turns into a broader outdoor project.
If your Wellborn fence is leaning, rattling, or the gate won’t close, call (850) 809-0306 for a free estimate. We’ll inspect the section, match the profile, and hand you a written price before any work begins.
Written by Luca Romano, Owner & Lead Contractor, Sawyer Remodel Orlando at Sawyer Remodel Orlando, serving Orlando and nearby areas.
