Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Fence Installation: The Orlando Owner’s Guide
Quikrete fence installation in Orlando typically runs $3,500 – $9,000 for a standard residential fence, depending on fence length, post depth, and whether we’re setting posts in existing concrete or pouring new footings. Most homeowners call us after a storm or a soft-ground shift: the fence is leaning, a post cap is cracked, or the concrete around a post has crumbled. We stock Quikrete-compatible posts, brackets, and setting mixes on the truck, and we can usually start within a few days of your call.
Quikrete makes the setting material, not the fence panels themselves, so the failure is almost always where the post meets the ground. In Orlando’s sandy, shifting soil, a post set too shallow in Quikrete starts to rack within two or three seasons. The concrete holds; the embedment depth fails. That’s the fix we do most often.
Which Quikrete Models This Applies To
Quikrete doesn’t sell fence panels, so there’s no “model number” on the fence side. The Quikrete products involved in fence installation are the setting mixes and anchoring materials: Fast-Setting Concrete Mix (red bag), Quikrete 5000 (for posts carrying gate hardware), and Quikrete High-Strength Anchoring Epoxy when a post has to bond to an existing slab or retaining wall. If you’re replacing a gate post or a corner post that sees real load, you want Quikrete 5000, not the fast-setting mix. We’ve pulled too many gate posts out of fast-set that cracked at the base because the mix didn’t reach full strength before the hardware went on.
The compatibility gotcha: Quikrete fast-setting mix is designed for posts 4×4 or smaller. When an Orlando homeowner upgrades to a 6×6 post for a taller privacy fence or a heavy automatic gate, fast-set doesn’t give enough bearing surface. We use Quikrete 5000 with a wider footing for anything over 4×4, and we reinforce it with rebar if the fence line runs near a drainage swale or a retention pond. Aftermarket post brackets are fine; aftermarket concrete is not worth the risk here.
Styles & brands we work with
Signs Your Quikrete Fence Installation Is Failing
- Post lean of more than 5 degrees. The Quikrete footing is intact but the embedment depth was too shallow for Orlando’s sandy soil, which loses bearing strength after heavy rain. You can shim it temporarily, but it’ll lean again within a season.
- Cracked or crumbling concrete at the post base. This usually means the mix was poured too dry, or water pooled around the base and then baked in the Florida sun. Once the top of the footing crumbles, water gets into the post and rot follows.
- Gate sag or drag on the latch side. The gate post is moving inside its Quikrete footing. The fix is a new, deeper footing with Quikrete 5000, not a hinge adjustment. Adjusting hinges on a moving post is rearranging deck chairs.
- Fence panels pulling away from posts. Orlando’s afternoon thunderstorms push saturated wind against the face of the fence, and over time the fasteners start to chew out of the post. The concrete isn’t the problem; the connection detail is.
- Water pooling at the base of posts after rain. The post footing was set too low or the grade wasn’t sloped away. In Orlando’s wet season, that water wicks into the post and the bottom of the pickets. You’ll see gray-bluish staining at the bottom of the fence first.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a typical 100-foot fence line in Orlando, a full Quikrete post reset plus panel reinstallation runs $3,500 – $9,000. The wide range comes down to a few things: whether we’re digging new footings or working with existing ones, how many posts have failed, whether the panels are wood, vinyl, or aluminum, and whether the fence sits on a slope or near water. A single failed gate post might run under $400 to reset properly; a full fence line with rotten bottom rails and failed footings across a sloped yard lands at the top of the range.
Every quote includes the parts, the concrete, the labor, and the cleanup. No allowance games. We write the price down before work starts, and the number on the invoice is the number you approved. The work is covered by our 365-Day Done Right Promise: if a post shifts or a footing cracks within a year, we come back and make it right, free of charge. That’s in writing.
DIY or Call Us?
You can safely check the obvious things yourself: wiggle the post, look for cracks at the base, check whether the gate hinges are pulling loose. But resetting a post on a load-bearing fence line is where DIY goes sideways. The digging is hard, the mix timing is unforgiving, and if the post isn’t plumb in both planes when the concrete kicks, you’re doing it twice. And if the fence is on a property line, get the survey right; Orlando has setback ordinances in some neighborhoods and moving a fence a foot the wrong way creates a dispute you don’t want.
We’re independent of Quikrete, but we install their products every week. If you’re in Orlando and your fence is listing toward your neighbor’s yard, call (850) 809-0306 and we’ll price the fix honestly.
FAQs
In Orlando’s sandy soil and wet-dry cycles, a properly set Quikrete post with adequate depth lasts 15 – 20 years before the post itself needs attention. The concrete usually outlasts the post. What fails first in this market is the wood making contact with wet soil, not the footing. Call (850) 809-0306 if your posts are leaning or the concrete is cracking at ground level.
Sometimes, but only when the concrete footing is sound and the post hasn’t rotted at the base. If the footing is cracked or the embedment is too shallow, the repair is a full dig-out and re-set. We’ll tell you which one you have within the first five minutes on site. Estimates are free.
A single post reset takes about a day, accounting for the fast-setting mix to firm up enough for panels to be reattached. A full fence line with multiple posts takes two to three days. We’ll give you a written timeline before we start.
Yes. We keep Quikrete Fast-Setting Concrete Mix, Quikrete 5000, and the standard bracket hardware on our trucks, so there’s no supply-run delay on most Orlando fence calls. If your job needs a special anchoring epoxy or a wider footing for a gate, we’ll source it before we show up.
Written by Luca Romano, Owner & Lead Contractor, Sawyer Remodel Orlando at Sawyer Remodel Orlando, serving Orlando and nearby areas.
